1 before each shift, must be in the activities of the components plus a lubricating oil. (manipulator, manipulator, rail clamping rail) 2 swing arm (3 - 4) a day. Heating machine chain and the small chain can be once a month. Check whether the main engine reducer, heater reducer is missing oil. Main bearing (3 - 2) plus one month. 3 before the production inspection of the moving parts is firm, the screw is 27SiMn
No loosening of the steel pipe is off, especially the strong impact of the local, belt drive part is abnormal. 4 check the high pressure air source, low pressure gas source, power supply, water supply is normal. 5 check the emergency stop switch, the security door switch, the protection device to detect the switch is normal. 6 check the temperature of the head into the embryo, the embryo part of the work is normal. If the embryo is not in place, the nut of the pressing device can be adjusted. 7 check whether the lamp tube is damaged or not. Should be replaced in a timely manner. 8 check whether the pneumatic components leak, the action is sensitive. 9. Check whether the three CIS abnormal leakage, blockage, water storage capacity is too full. 10 blowing machine solenoid valve in case of abnormal, should be promptly cleaned (3 million 500 thousand times per bottle blowing). 11 blow bottle mold must be cleaned regularly, polishing. 12 open the high pressure gas source switch must slow action, to prevent air flow too fast dirt blown into the solenoid valve, the exhaust valve is opened at the same time 30 seconds, to ensure clean air. 13 machine starting must be sure that the mechanical part is good, no one inside the machine, no foreign body. Especially the handle position, to avoid wounding. At the same time to close the security door. 14 start the machine must start the motor, delay 30 seconds to start the heating machine, in order to prevent the voltage fluctuation.
Before starting the cold heading machine price to determine the heating cooling water does not open. 15 minutes after the start of heating (2-3), when the oven temperature rise evenly, press the button in the embryo. At the same time, the power to open the bottle, or not blowing the bottle. 16 machine operation must pay close attention to whether the machine has abnormal noise, to achieve early detection, timely stop early settlement. 17 in case of emergency, can press the emergency stop button, emergency brake. Then according to the analysis of the causes of the formation of the situation, to find a quick solution to the problem. 18 after the normal operation of the machine, any part of the body do not put into the machine in order to avoid mechanical wounding. If the machine has abnormal sound can be observed after the deceleration. 19 after the normal production of the machine, the operator should always observe the quality of the bottle, so as to avoid the fluctuation of voltage or other reasons. 20 plastic blow molding machine maintenance, can press the screen failure repair button to ensure the safety of maintenance. Please note the position of the robot hand if you need to observe the action of each module separately. At the same time, be sure to clear the role of a separate button, and then in the action. Make sure that the wrong actions cause unnecessary trouble. 21 plastic blow molding machine after each repair, must clean up tools and screws and the like, so as to avoid the legacy of the machine, affecting the normal operation of the machine.